Solution for quickly aggregating UTXOs regarding the bitlight Wallet

1 Ensure the Wallet has no rgb no rgb no rgb
2 This method is used only to consolidate UTXO and does not involve any consolidation of RGB assets.
3 Using this method, the wallet's utxo will be directly merged into the target address. If RGB assets exist, they will be burned and cannot be recovered.

Read it once before use 1 2 3 Because the Wallet has RGB, burn the RGB assets after aggregation.
No responsibility taken

Tool Link

Before use, explain the types of derived addresses for the bitlight Wallet.

Wallet btc receive: m/86'/0'/0'/0/0
Wallet balance payment: m/86'/0'/0'/1/0
The address for the first UTXO creation: m/86'/827166'/0'/0/0

RGB assets exist in UTXO addresses. Do not use this derived address m/86'/827166'/0'/0/0 for RGB assets.

Each time the RGB transfer occurs, the UTXO-derived addresses will change to m/86'/827166'/0'/0/1, m/86'/827166'/0'/0/2, m/86'/827166'/0'/0/3, and so on.

1. Import the mnemonic phrase and set the derived address as shown in Figure 1.

2 As shown in Figure 2. Set the relevant derived address types. Before performing this operation, ensure that the Wallet has no rgb assets. Ensure that the Wallet has no rgb assets.

3 As shown in Figure 3. You can check the current gas on the block explorer, just lower it a bit and wait for the block to be confirmed.

It is emphasized again that this operation is only for merging UTXO after transferring RGB. If there is RGB in the wallet and using this method results in the loss of RGB, we are not responsible.